ldd-350h blank : pin style w : wire style w file name:ldd-h-spec 2011-10-07 constant current output: 300ma to 1000ma wide input voltage: 9 ~ 56vdc wide output led string voltage: 2 ~ 52vdc high efficiency up to 97% dc/dc step-down converter built-in emi filter, comply with en55015 and fcc part15 without additional input filter and capacitors built-in pwm and remote on/off control protections: short circuit / over temperature cooling by free air convection compact size low cost, high reliability suitable for driving illumination led 3 years warranty fully encapsulated with ip67 level specification ldd-300h ldd-350h ldd-500h ldd-600h ldd-700h ldd-1000h order no. current range voltage range current accuracy (typ.) output efficiency (max.) dc current input pwm dimming & on/off control environment emc working temp. working humidity storage temp., humidity temp. coefficient vibration operating case temp. (max.) mtbf dimension others weight potting material short circuit filter remote on/off pwm frequency quiescent input in shutdown mode(max.) current over temperature protection ripple & noise(max.) note.2 switching freqency external capacitance load (max.) 97% at full load and 36vdc/48vdc input 270ma 10ma 9 ~ 56vdc 2.2uf 40khz ~ 1000khz 150mvp-p 3% at 24vdc input ; 4% at 48vdc input 2 ~ 52vdc 300ma 350ma 150mvp-p 320ma 500ma 150mvp-p 450ma 600ma 200mvp-p 550ma 700ma 1000ma 200mvp-p 350mvp-p 650ma 900ma 2000khrs min. mil-hdbk-217f (25 ) -40 ~ + 85 (refer to derating curve) 20% ~ 90% rh non-condensing -55 ~ +125 , 10 ~ 95% rh 0.03% / 10 ~ 500hz, 2g 10min./1 cycle, period for 60min. each along x, y, z axes 100 31.8*20.3*12.2mm or 1.25"*0.8"*0.48" inch (l*w*h) ldd-h:16g ; ldd-hw:18.6g expoxy(ul94-v0) full load note.3 no load capacitor leave open if not use power on with dimming: dim ~ -vin >2.5 ~ 6vdc or open circuit power off : dim ~ -vin < 0.8vdc or short 100 ~ 1khz 1ma at pwm dimming off and 24vdc input dc-dc constant current led driver l d d - h s e r i e s features : voltage range tj 150 typically(ic1) detect on main control ic regulated at rated output current protection type: can be continued, recovers automatically after fau lt condition is removed protection type : shut down, recovers automatically after temperatu re goes down ems immunity compliance to en55015, fcc part 15 class b compliance to en61000-4-2,3,4,6,8, light industry level, criter ia a emi conduction & radiation 1.all parameters are specified at normal input(48vdc), rated load, 25 70% rh ambient. 2.ripple & noise are measured at 20mhz by using a 12" twisted pair terminated with a 0.1uf capacitor. 3.test condition: 48vdc input. note
31.8[1.25] 11 2 21 14 21 23 11 2 bottom view pwm dimming control 0 25 50 75 100 25 50 75 100 pwm signal output current during pwm dimming operation, the output current will change to pwm style. h max l0 off off off on on 100~1khz on duty cycle (%) i out (% ) dc-dc constant current led driver l d d - h s e r i e s file name:ldd-h-spec 2011-10-07 tol : 3%(typ.) mechanical specification unit: mm (inch) blank type(ldd - - - - h): hw): w type(ldd pin configuration derating curve 14 13 12 11 23 24 22 2 1 bottom vi ew side vi ew side vi ew 12.2 [0.48] 20.3[0.80] 100 10mm 5 2mm 12.2 [0.48] 2.06 [0.08] 3.81 [0.15] 2.5 4 [0.1] 20.3 [0.80] 31.8 [1.25] 15.24 [0.60] note:pin size tolerance 0.60 0.05mm ta ( ) load (%) -40 0 25 50 71 85 50 25 75 100 100 pin no. pin no. 23,24 23 1,2 2 (black) (blue) (yellow) (white) (red) 11,12 11 13,14 14 22 21 output output +vin +vin -vin -vin -vout -vout +vout +vout pwm dim pwm dim comment comment dc supply dc supply don't connect to -vout don't connect to -vout led - connection led - connection led + connection led + connection on/off and pwm dimming (leave open if not used) on/off and pwm dimming (leave open if not used) 71 for 600~1000ma 85 for 300~500ma
dc-dc constant current led driver l d d - h s e r i e s file name:ldd-h-spec 2011-10-07 65.0% 70.0% 75.0% 80.0% 85.0% 90.0% 95.0% 100.0% 1 2 3 4 5 6 7 8 9 10 11 12 13 14 300ma 350ma 500ma 600ma 700ma 1000ma 70.0% 75.0% 80.0% 85.0% 90.0% 95.0% 100.0% 1 2 3 4 5 6 7 8 9 10 300ma 350ma 500ma 600ma 700ma 1000ma 75.0% 80.0% 85.0% 90.0% 95.0% 100.0% 1 2 3 4 5 6 7 300ma 350ma 500ma 600ma 700ma 1000ma 80.0% 85.0% 90.0% 95.0% 100.0% 1 2 3 300ma 350ma 500ma 600ma 700ma 1000ma efficiency vs output voltage(number of leds) fig-1 12vdc input, 1~3 leds(vf=3v) fig-2 24vdc input, 1~7 leds(vf=3 v) fig-3 36vdc input, 1~10 leds(vf=3v) output voltage(leds) output voltage(leds) output voltage(leds) efficiency (%) efficiency (%) efficiency (%) 80% 85% 90% 95% 100% 1 2 3 80% 2 3 4 5 6 7 75% 1 80% 85% 90% 95% 100% 3 4 5 6 7 8 9 10 75% 70% 1 2 70% 65% 75% 4 5 6 7 8 9 10 11 12 13 14 1 3 2 300ma 350ma 500ma 600ma 700ma 1000ma 300ma 300ma 300ma 350ma 350ma 350ma 500ma 500ma 500ma 600ma 600ma 600ma 700ma 700ma 700ma 1000ma 1000ma 1000ma fig-4 48vdc input, 1~14 leds(vf=3v) output voltage(leds) efficiency (%) 85% 90% 95% 100% 80% 85% 90% 95% 100% standard application +vin +vout -vin h: >2.5~6vdc or open circuit l: <0.8vdc or short -vout 1st led last led h pwm dimming ldd-h l
|